Sanyo PLC-WTC500AL - Installation: Video Connectivity; Video, HDMI, and Scart Connections

21
Connecting to Video Equipment (Video, S-video, Component, HDMI and RGB Scart)
Cables used for connection
• Video Cable (RCA x 1) • VGA-Scart Cable
• S-VIDEO Cable • BNC Cable
• HDMI Cable
(Cables are not supplied with the projector.)
VIDEO
S-VIDEO
S-video
cable
Composite
Video
Output
S-video
Output
VIDEO
Unplug the power cords of both the projector and external
equipment from the AC outlet before connecting cables.
✔Notes:
•WhentheStandbymodeissetto“Eco“intheSetting,
MONITOROUTandAUDIOOUTaredisabled.(p.56)
BNC
cable
Installation
HDMI
MONITOR
OUT
BNC
cable
HDMI
cable
VGA-
Scart
cable
RCA
cable
Y Pb/Cb Pr/Cr
VGA-
Scart
cable
ANALOG
IN
Digital
Output
RGB Scart
21-pin Output
Refer to the
Monitor Out
Signal Table
(next page).
Composite
Video
Output
Component Video
Output
(Y Pb/Cb Pr/Cr)