Sanyo PLC-WTC500AL - Input Selection: Source Configuration; Input Source and Signal Format

35
Press the MENU button to display the On-Screen
Menu. Use the Point 7 8 buttons to move the red
frame pointer to the Input Menu icon.
1
Use the Point ed buttons to move the red arrow
pointer to the desired input and then press the
SELECT button. The signal format menu appears.
2
Use the Point ed buttons to select the desired signal
format and then press the SELECT button.
3
Menu Operation
When the RGB PC (analog) signal is
connected
RGB (PC analog)
INPUT 1
When the HDMI signal is connected.
HDMI
When the RGB PC signal is connected.
RGB
INPUT 2
When the video signal is connected.
Video
When the component signal is
connected.
Component*
INPUT 3
When the video signal is connected.
Video*
When the S-video signal is connected.
S-video*
Input Source Selection
* If the projector cannot reproduce proper video image, select a
system manually (see “Video System Selection” on page 36)
*”Component” can accept the component signal and the analog
RGB signal.Some unsupported RGB signals may be detected to
 component signals. In this case, please set to “RGB”manually.
* If the projector cannot reproduce proper video image, select a
system manually (see “Video System Selection” on page 36).
When the RGB PC (scart) signal is
connected
RGB (Scart)
Input Menu
Input Selection