Sanyo PLC-WTC500AL - Part Names and Functions: Terminals; Side Terminal Connections

11
Side Terminal
q
w e r
t
i
u
yAUDIO 2 JACK
Connect the audio output (stereo) signal from a
computer or video equipment connected to i to
this jack (p.22).
tAUDIO 1 JACK
Connect the audio output (stereo) signal from a
computer or video equipment connected to q or
w to this jack (p.22).
uAUDIO 3 JACKS (L(MONO)/R)
Connect the audio output signal from video
equipment connected to o or !2to these jacks
(p.22). For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack.
i5 BNC INPUT JACKS
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Cb/Pb,
and Cr/Pr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.20-
21).
wCOMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal
to this terminal (p.20).
qHDMI TERMINAL
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (p.20).
o
Part Names and Functions
rMONITOR OUTPUT TERMINAL (ANALOG)
This terminal outputs the video signal from
computer to external video equipment (p.21).
eAUDIO MONITOR OUTPUT JACK (VARIABLE)
This jack outputs the audio signal from computer
or video equipment to external audio equipment
(p.22).
y
oS-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).