Sanyo PLC-XF47 - Page 74

Optical adjustment
- 74 -
●
Relay Lens, Condensor Lens adjustment tool installation.
1. Remove the Polarized glass units (R, G, B).
Remove 6 screws-A and remove the Polarized glass units.
A
A
A
A
A
A
Polarized glass
units (R, G, B)
2. Replace the Optical lter units.
Remove screw-B and remove Optical lter unit.
Replace the each adjustment tool (Red, Green, Blue).
Tighten screw-B.
(The Adjustment tools are same as.)
B
Adjustment tool
Optical lter unit
3. To install the Polarized glass units, take reversed step in the above.
Tighten 6 screws-A and install the Polarized glass units.
Note: After adjustment, the adjustment tools are replaced Optical lter units.
Replace the Adjustment tool
When adjusting the Relay lens and Condensor lens,
Adjustment Tool is needed.
3 adjustment tools are necessary for the adjustment.
(Red, Green, Blue)
Adjustment tool
Relay lens and Condensor lens Adjustment Tool
can be ordered.
Give the following information to the dealer.
Part Name ; OPTICAL FILTER-S
Service Parts No. 610 337 6394