■
Security Function Notice
This projector provides security functions such as "Key lock", "PIN code lock" and "Logo PIN code lock". When the projector has
set these security function on, you are required to enter correct PIN code to use the projector. If you do not know the correct
PIN code to the projector, the projector can no longer be operated or started. In this case, you must reset those function rst
according to the resetting procedure described below and then check up on the projector.
Function Description
Key lock
Locks operation of the side control or the remote control.
If the Key lock is enabled with side control lock, the projector can no longer
stated.
Initial setting : Key lock function is disabled
PIN code lock
Prevents the projector from being operated by an unauthorized person.
Initial code : "1234"
Logo PIN code lock
Prevents an unauthorized person for changing the start up logo on the
screen.
Initial code : "4321"
Resetting procedure
1. Turn o the projector. (AC switch o.)
2. As pressing the "SELECT" button on the projector, turn on the projector again. (AC switch on.)
Keep pressing the "SELECT" button until the "READY" indicator lights continuously.
This is complete the resetting of the security function. The PIN code lock and Logo PIN code lock are reset as the initial
PIN code at the factory and Key lock function is disabled.
Please refer to the owner's manual for further information of the security functions.
- 9 -
To Next Page
Loading...
