Sanyo PLC-XK2200 - Page 26

26
Basic Operation
126+2:EXWWRQ
Press the P-TIMER button on the remote control to
operate the Count up/Count down function. Refer to p.50
for detail of Setting for the P-timer function.
To stop the count time, press the P-TIMER button.
To cancel the P-timer function, press and hold the P-
TIMER button.
37,0(5EXWWRQ
Press the IMAGE button on the remote control to select
a desired image mode of the screen. See pages 32, 39
for details.
,0$*(EXWWRQ
1RVKRZdisappears after 4 seconds.
31RWH
See the previous page for the description of
other buttons.
Select the screen size (See pages 34-35, 42-43 for
details).
6&5((1EXWWRQ
EODFNRXWĺWKHFDSWXUHGLPDJHĺQRUPDOĺ
•••••
Press the NO SHOW button on the remote control to
black out the image. To restore to normal, press the NO
SHOW button again or press any other button. When
the projected image is captured and is set as User in the
Logo selection (p. 46), the screen changes each time
you press the NO SHOW button as follows.
31RWH
When use the MUTE button to release the
No Show function, the mute function can not
be operated at the same time.
,0$*(EXWWRQ
126+2:EXWWRQ
37,0(5EXWWRQ
6&5((1EXWWRQ
5HPRWH&RQWURO
1R6KRZ
37LPHU