Sanyo PLC-XK2200 - Page 28

28
&RPSXWHU,QSXW
3&6\VWHP0HQX
3&6\VWHP0HQX
&RPSXWHU6\VWHP6HOHFWLRQ
This projector automatically tunes to various types of computers with its Multi-scan system and Auto PC Adjustment. If
a computer is selected as a signal source, this projector automatically detects the signal format and tunes to project a
proper image without any additional settings. (Signal formats provided in this projector are shown on page 70.)
One of the following messages may appear when:
When the projector cannot recognize
the connected signal conforming to the
provided PC systems, $XWR is displayed
on the System Menu box and the Auto
PC Adjustment function works to display
proper images. If the image is not projected
properly, a manual adjustment is required
(pp. 30-31).
There is no signal input from the
computer. Check the connection between
your computer and the projector. (See
“Troubleshooting” on p. 63.)
$XWR
-----
The preset system is manually adjusted in
the PC adjust Menu. The adjusted data can
be stored in 0RGH± (pp. 30-31).
Mode 1
PC Systems provided in this projector is
chosen. The projector chooses a proper
system provided in the projector and displays
it.
69*$
*Mode 1 and 69*$ are examples.
1
2
PC system can also be selected manually.
Selecting Computer System Manually
Press the MENU button to display the On-Screen
0HQX8VHWKH3RLQWŸźEXWWRQVWRVHOHFW,QSXW
and then press the Point Ź or the SELECT button.
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW6\VWHP and
then press the Point Ź or the SELECT button.
8VHWKH3RLQWŸźEXWWRQVWRVHOHFWWKHGHVLUHG
system and then press the SELECT button.
3
Selected system in the
PC System Menu is
displayed.
Systems in this dialog box
can be selected.
Customized Mode
± set in the PC
adjust Menu (pp.
30-31).