A3
SCH_KM3AB
CAUTION
Components indicated by a mark ! in this schematic diagram designate
components in which safety can be of special significance. It is, therefore,
particularly recommended that the replacement of these parts must be
made by exactly the same parts.
This projector is isolated AC line by using the internal converter trans-
former.
Please pay attention to the following notes in servicing.
(1) Do not touch the part on hot side (primary circuit) or both parts on
hot and cold sides (secondary circuit) at the same time.
(2) Do not shorten the circuit between hot and cold sides.
(3) The grounding lead must be connected to the ground of the same
circuit when measuring of voltage and waveforms.
SECONDARY CIRCUIT
PRIMARY CIRCUIT
Schematic Diagrams
HOT
COLD
CAUTION
Fuse of the specified parts number must be used.
Unauthorized substitutions may result in fire or accident.