14
Chapter 3 Basic Operation
Displaying all the status information of the target
Select a target and click button on the tool bar. The following status window appears
and displays all the available status information of the target.
The target name and item which have an
abnormality or connection error happen-
ing are indicated with red.
When PJ Network Manager cannot
acquire the value of column information,
"---" is displayed.
Stopping monitoring the target
To stop monitoring the target, click button again on the tool bar.
The projectors setting different network passwords cannot be set to the same group. It is
necessary for the projectors in the same group to set to the same password.
The above procedure can perform by selecting Target display from Display menu.
Setting the target group
The target group can be set up by the procedure below. When you set a command in the
same group, you set it.
1 Select targets which you want to set from the status list. Select Group setting from
Target menu, the dialog box will appear as the below figure.
2 Select a group, and then click OK button.
"---" will not set the group.
To Next Page
Loading...
Need help?
General
