EasyManuals Logo

Sanyo SAP-DMRV183GJ User Manual

Sanyo SAP-DMRV183GJ
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
HIGH POWER
Raises the power but remains in the same operating mode.
This function is set with the HIGH POWER button on the remote
controller.
(It is set regardless of the temperature and fan speed settings.)
HIGH POWER operation from the remote controller
The unit operates at maximum output for 15 minutes,
regardless of the desired temperature.
The fan speed is 1 step above “High.”
Lamp colors
ON timer operation
Operation lamp
DRY operation : Orange
COOL operation : Green
TIMER lamp : Green
ECONOMY
NOTE
When HIGH POWER operation ends, the unit operates at low
Hz for 5 minutes, regardless of the thermostat OFF conditions.
When in DRY mode, operation is in the cooling zone.
HIGH POWER operation cannot be set from the remote
controller when the unit is stopped.
HIGH POWER operation and ECONOMY operation cannot be
used at the same time. The function set last takes priority.
NOTE
This function does not operate if the ON timer standby time is
less than 30 minutes.
Operation starts when the time set for the ON timer is reached.
When a time is set, the TIMER lamp illuminates.
The below comfort timer programming is performed.
A comfort time is calculated from the set temperature and the
room temperature, either 60 minutes prior or 30 minutes prior to
the set ON timer time, and operation is started in advance of
the set ON time. (The indoor fan speed is “Medium.”)
[COOL]
Indoor temperature – Set temperature = Temperature difference
OFF timer operation
Operation stops when the time set for the OFF timer is
reached.
When a time is set, the TIMER lamp illuminates.
Timer backup
If the indoor unit is unable to receive the timer time-end signal
when the ON or OFF time is reached, then timer time-end
occurs according to the indoor unit backup timer within
approximately 26 minutes.
Operation stops if there are no operator controls for 25 hours or
longer after unit operation switched from OFF to ON by use of
ON timer operation.
Frequency
MAX
0
Start End
Time
15 min. 5 min.
When ECONOMY operation is set, the temperature and fan
speed settings will be adjusted automatically to allow
comfortable sleep.
When ECONOMY operation is set, “ mark” appears on the
remote controller.
COOL and DRY modes
The indoor unit fan speed is automatically lowered for quiet
operation.
The temperature setting is raised by 1°C one hour after
ECONOMY operation is set.
Temperature difference (°C) Advance start time (min.)
12 < Temperature difference
60
6 < Temperature difference
30
26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo SAP-DMRV183GJ and is the answer not in the manual?

Sanyo SAP-DMRV183GJ Specifications

General IconGeneral
BrandSanyo
ModelSAP-DMRV183GJ
CategoryAir Conditioner
LanguageEnglish

Related product manuals