6
Remote Control Receiver and Operation Selector
Remote control receiver This section picks up infrared signals from the remote control unit
(transmitter).
Operation selector
ON position This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
OFF position Switch the selector to the OFF position if you are not going to use the
air conditioner for a few days or longer.
WARNING The OFF position does not disconnect the power. Use the main power
switch to turn off power completely.
TEST position This position is used only when servicing the air conditioner.
CAUTION Do not set at the TEST position for normal operation.
OPERATION lamp This lamp lights when the system is in the continuous AUTO (orange or
green), DRY (orange) and COOL (green) mode.
TIMER lamp This lamp lights when the system is being controlled by the timer.
OI-645-06EG
OPERATION lamp
Receiver
TIMER lamp
Operation selector
IMPORTANT
Avoid using radio equipment such as mobile phone near
(within 1 m) the remote control receiver. Some radio
equipment may cause malfunction of the unit.
If the trouble happens, disconnect power and restart the air
conditioner after a few minutes.
To Next Page
Loading...
Need help?
General
