Unit Display and Operation Selector
Remote control receiver This section picks up infrared signals from the remote control
unit (transmitter).
Operation selector
ON position This position is for operating the air conditioner with the
wireless remote control unit.
Set the selector to this position for normal operation.
OFF position Switch the selector to the OFF position if you are not going to
use the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
TEST position This position is used only when servicing the air conditioner.
CAUTION
Do not set at the TEST position for normal operation.
OPERATION lamp This lamp lights when the system is in the continuous AUTO,
HEAT, DRY and COOL mode.
STANDBY lamp This lamp lights during the warm up period for heating and
when the system is defrosting. To keep a constant room
temperature, the air conditioner continues to supply a gentle
breeze during warm up or when the heating operation is
interrupted by the thermostat.
TIMER lamp This lamp lights when the system is being controlled by the
timer.
OPERATION lamp
TIMER lamp
Remote control receiver
INDOOR UNIT
STANDBY lamp
IMPORTANT
Avoid using radio equipment
such as mobile phone near
(within 1 m of) the indoor unit.
Some radio equipment may
cause the unit to malfunction.
If the trouble occurs, dis-
connect power and restart the
air conditioner after a few
minutes.
Operation selector
6 OI-396-06EG
oi396000
To Next Page
Loading...
