Sanyo VCC-XZ200P - AWC SETTING (One-Push Adjustment)

17
Adjusting White Balance <WHITE BALANCE>
1
Select “AWC LOCK” – “SET”.
2
Point a camera to a white paper or wall to project
an image on the whole screen, and press the SET
button.
RThe cursor “q” lights off, and white balance adjustment will
start. The adjustment will end after about 2 seconds when “q”
lights again.
• If the adjustment does not yield a satisfactory result, press the
SET button again.
■ To perform fine adjustment of color
In the “AWC SETTING” screen, select “GO TO MWB” – “SET”, and
press the SET button.
RThe “MWB SETTING” screen appears. Specify values manually.
(See next page)
3
Set “MENU” to “END” and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select “BACK” and
press the SET button.
AWC SETTING (One-Push Adjustment)
AWC SETTING
·AWC LOCK
GO TO MWB
SET
SET y
·AWC LOCK
(SET)
SET
White paper or wall
MEMO: Transferring to the “MWB SETTING” through “GO TO MWB”,
white balance mode (see page 16) will be changed to
“MWB”.
L5BJ2_XE(GB).book 17 ページ ２００６年３月２２日 水曜日 午後３時４９分