24
Adjusting DAY/NIGHT Function <DAY/NIGHT>
1
Select “LEVEL” and specify a level for DAY/
NIGHT switching.
2
Set “BURST” to “ON” or “OFF” for the burst
signal*.
3
Set “MENU” to “END” and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select “BACK” and
press the SET button.
DAY/NIGHT SETTING-AUTO
LOW : Switches in darker conditions; i.e., color shot is preferred
so that it does not switch from COLOR to B/W until it gets
dark.
HIGH : Switches in brighter conditions; i.e., black-and-white shot
is preferred so that switching from COLOR to B/W can
easily occur when it gets a little bit dark.
ON : This is effective if you observe any disturbance of picture
caused by switching from color to black-and-white mode
of a monitor, in particular when peripheral devices such as
a switcher unit are connected.
OFF : The burst signals are unused.
DAY/NIGHT SETTING
·LEVEL
BURST
LOW
OFF
·LEVEL
DAY/NIGHT SETTING
LEVEL
·BURST
LOW
OFF
·BURST
Note:
• If an infrared lighting system is used, the B/W mode may switch
to COLOR when a subject reflects the light intensely. Set the
infrared system in an appropriate location that does not affect the
shot.
• The motion sensor detection will be interrupted during switching
over from B/W to COLOR mode and from COLOR to B/W mode.
* The burst signals are color synchronization signals required for
reproducing color.
L5BJ2_XE(GB).book 24 ページ ２００６年３月２２日 水曜日 午後３時４９分
To Next Page
Loading...
