Sanyo VCC-XZ200P - DAY;NIGHT SETTING-B;W (Black-And-White)

25
Adjusting DAY/NIGHT Function <DAY/NIGHT>
1
Set “BURST” to “ON” or “OFF” for the burst
signal*.
2
Set “MENU” to “END” and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select “BACK” and
press the SET button.
DAY/NIGHT SETTING-B/W (Black-and-white)
ON : This is effective if you observe any disturbance of picture
caused by switching from color to black-and-white mode
of a monitor, in particular when peripheral devices such as
a switcher unit are connected.
OFF : The burst signals are unused.
DAY/NIGHT SETTING
·BURST
PRESET
MENU
OFF
OFF
BACK
·BURST
* The burst signals are color synchronization signals required for
reproducing color.
L5BJ2_XE(GB).book 25 ページ ２００６年３月２２日 水曜日 午後３時４９分