Sanyo VCC-XZ200P - Page 31

30
Specifying Alarm Input <ALARM>
5
Select “uSENSITIVITY” and press the SET
button.
RThe “SENSITIVITY” screen appears.
6
Select “<MOVE>” and specify a sensitivity level
(1 –10).
RThe greater the number, the lower the responsiveness to
movement becomes.
7
Select “<TIME>” and specify a detection time of
duration (1 – 60).
RThe greater the number, the lower the detectability against
fast-moving subjects.
■ To confirm the sensitivity of the motion detection
Select “TEST” and press the SET button.
• Make sure that the motion-detected area is properly specified by
placing your hand or other objects in front of the lens.
To finish the test, press the SET button.
8
Set “MENU” to “END” and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select “BACK” and
press the SET button.
Motion Sensor Setting (continued)
ALARM SETTING
ALARM IN
MOTION
uAREA
·uSENSITIVITY
ZOOM
uZOOM TIME
DURATION
ALARM SIGN
NO
ON
SET y
SET y
OFF
5S
5S
OFF
·uSENSITIVITY
(SET)
SET
R
SENSITIVITY
<MOVE>
· 5
<TIME>
1
TEST
PRESET
MENU
SET y
OFF
BACK
·<MOVE>
MEMO:
Alarm sign indicates when any moving subject is detected
(See page 32).
L5BJ2_XE(GB).book 30 ページ ２００６年３月２２日 水曜日 午後３時４９分