i
This VCR has a built-in tuner capable of memorizing up to 44
television channels.
You can select any position from 1 to 44 to preset the channels
that can be received in your area.
Before starting
Set the TV receiver channel to the preset video channel or to
the AV mode.
Example: To preset UHF channel “23”
to channel
position “1”.
O Press
the PRESET button.
This
will activate the channel preset mode and the channel
position number will start to blink.
Channe~ position number
@Select the desired channel position number (Example: “1”)
by pressingthe CHANNEL (+ or -) buttonor the numeric
button.
Then, press the OK button.
o Press the CHANNEL (+ or -) button to tune the broadcast
you want to assign to that position number.
The CHANNEL (+) button will access the following
broadcast.
The CHANNEL (-) button will access the previous
broadcast.
The picture from the selected channel will appear on the
screen.
Broadcast tuning i~dicators
mm
O When the broadcast from the desired channel (Example:
channel 23) is received, press the OK button.
If the tuning of a channel is not optimum, it can be improved by
manual fine tuning.
OSelect the channel with the unsatisfactory broadcast.
@Press the PRESET button twice.
@Press the CHANNEL (+ or -) button to obtain the best
picture and sound.
~ When the best picture and sound are obtained press the
OK button.
Channel 23 has been preset to channel position number
“1”.At that time the channel position number will change
from
“l”to “2”.
To assi n a channel to another position number, repeat
steps
do
to’.
@Press the PRESET button.
To Next Page
Loading...
