Sanyo XM150 - Page 25

-25-
Mechanical Disassembly
10. A/V Board Assy removal
1. Remove the Filter Cover by pulling it outside.
2. Remove 4 screws-A (T3x8) and 1 screw-B (M3x8) and pull the Filter Box
assy upward off.
11. Fans (FN908, FN909, FN910) removal
1. Remove 3 screws-A (T3x15), 1 screw-B (T3x8) and unhook 2 hooks and
remove the Duct Panel Top.
2. Remove 3 screws-C (T3x8) to take the Duct PBS off.
3. Remove 3 screws-D (T3x12) and 3 screws-E (T3x8) to take the Duct Fans
assy off.
A
Filter box assy
T3x8
Filter cover
A
A
A
T3x8
T3x8
T3x8
T3x8 x3
T3x8
T3x8
T3x8 x2
FIlter
motor
(M901)
AMF
sensor
board
Filter
switch
(SW1891)
A
A
C
C
C
D
D
D
A
E
E
Duct PBS
Duct panel top
Duct fan assy
T3x12
T3x12
T3x12
T3x8
FN909
FN910
FN908
Sensor A
board
E
B
Hook
B