20
Data Interface
lf you wish to document your weighing data with the Sartorius
Data Printer, connect the printer's interface connector to the in-
terface port (17) on the balance. You do not need to change any
settings!
To do this, remove the protective cap from the data interface port.
- Plug the interface connector into the interface port
- Secure the interface connector by tightening the screws
Important Note
Make sure to unplug the AC adapter from the wall outlet before you
connect or disconnect additional devices (printer or PC) to or from the
balance interface port.
Press the
key
(14)
for data output.
See page 24 for information on data output parameters and data ID
codes. For more information about the data interface (e.g. data output
and input formats, pin assignment, etc.), see the enclosed "Interface
Description."
To Next Page
Loading...