| 11
Accessing and Setting the Balance Operating Menu
Accessing the Menu Using the „e“ „t“ keys:
- Turn the balance/scale off and back on by pressing the e button.
- While all segments are displayed (Segment Test), briefly press t.
- „1“ is displayed.
Note:
If „ -1“ is displayed, this indicates that the operating menu is blocked by the menu
access switch (see fi gure on the left). Menu code setting „ 8 1 2 „ (read only
parameters) is activated.
To unlock the menu to change the menu code settings, move the menu access
switch to the left.
Move the switch back to the right after you have made your changes!
Selecting a Menu Code Setting Using the „q“ and „p“ Keys:
- Press q to select the desired number. Numbers increase by one each time
they are pressed and go from 9 back to 1 again (1, 2, 3 ... 8, 9, 1 ...).
- Press p to move from the first code number to the second and third numbers
(1st - 2nd - 3rd etc.). Numbers increase by one each time they are pressed and go
from 3 back to 1 again (1st - 2nd - 3rd - 1st etc.).
Changing and Storing a Setting with the „t“ Key:
- Briefly press one of the t keys to confirm desired setting. A „°“ appears after
the new setting, e.g. „3-1-3 °.“
- To store the setting, press one of the t keys for more than two seconds.
Anz_01-F.eps
Anz_02-F.eps
Balance Operating Menu
Anz_04-F.eps
Anz_03-F.eps
To Next Page
Loading...
Need help?
General
