| 31
External Adjustment
Note: The external calibration/adjustment can be performed in various ways.
Only use calibrated weights!
1. As described in this manual,
2. or using the Sartorius MC1 Server (Version 4.9 or later) or the SARTOCAS
program for PCs and laptops).
- Make sure that the balance/scale operating menu is set to the code „1 9 1 -
external calibration/adjustment accessible“ (see pages 13-14 „Operating Menu
Settings“) or „1 9 7 - external adjustment/calibration/", the Access Lock Switch
has to be closed.
- If necessary, tare the balance/scale by pressing the t key. Press q to
activate the calibration/adjustment routine.
- The calibration weight required is displayed, (depending on the model, e.g.
CP225D).
Caution! The balance/scale only accepts a weight that is within a tolerance range of
approx. 2% of the nominal value. Errors exceeding this tolerance range can only
be corrected using the SARTORIUS MC1 Server Software.
- Center the required weight (e.g. 200g/E1) on the weighing pan and close the
draft shield.
- After the calibration weight has been stored, the balance will return to the
weighing mode.
– Menu »1 10 2 Calibration/Adjustment« calibration weight value will be displayed
first, then press q key.
Overwriting the Internal Calibration Weight
Caution! The internal calibration weight on CP balances/scales should only be overwritten
using the PSION Server or the SARTOCAS program for PCs and laptops, since the
factory setting of the internal calibration weight is highly accurate. Only in the
case of emergency (e.g. no service software available) should you perform the
overwrite protection using the balance‘s overwrite program).
Important: Before carrying out the overwriting internal calibration weight, you must cor-
rectly adjust the span.
The balance/scale must warm up for at least 4 - 24 hours!
Note: There are various ways of overwriting the internal calibration weight on CP balances/
scales.
1. As described in this manual
2. or using the Sartorius MC1 Server (Version 4.9 or later) or the SARTOCAS
program for PCs and laptops).
Anz_14-F.eps
Anz_15-F.eps
Anz_16-F.eps
Waags_Just.eps
Front
Span Adjustment
To Next Page
Loading...
Need help?
General
