Sartorius EVO1S1 - FCC Suppliers Declaration of Conformity

To Next Page

To Previous Page

EVO1S1 | SPO1S1 Operating Instructions 39

Conformity & Licenses

upplier’s Declaration of Conformity

___________________________________________________________________________________________

Doc: 2399148-00 SLI18FCC005-00.en 1 / 1 PMF: 2025573 OP-113_fo1_2015.10.12

evice type Paint mixing scale

ype series EVO1S1... , SPO1S1...

Party issuing Supplier’s Declaration of Conformity /

esponsible Party – U.S. Contact Information

Sartorius Corporation

5 Orville Dr Suite 200

11716 Bohemia, NY

USA

Telephone: +1.631.254.4249

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

nformation to the user

Note: This equipment has been tested and found to comply with the limits for a c

lass B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Connections between the device and peripherals must be made using shielded cables in order

to maintain compliance with FCC radio frequency emission limits.

Any modifications made to this device that are not approved by Sartorius may void the

authority granted to the user by the FCC to operate this equipment.

FCC

Other manuals for Sartorius EVO1S1