22
After you have accessed the menu of the scale operating program,
the display will show a continuous numerical sequence from 0 to 5 for
the "page" or the first digit of the code, in addition to the Status code
letter "
L
" or "
C
".
When the first digit of the code you wish to check or change appears,
press the tare control
(6)
. The "page" code number now stops in the
display, and a series of numbers for the 2nd digit or ''line" will begin to
cycle. Press the tare control again to stop the code number of your
choice in the display. Next, the numbers for the "word" (last digit) will
cycle in the display. Repeat the procedure to enter the last digit of the
code.
The "o" symbol that appears indicates the actual setting.
To change any settings ("C" mode), press the tare control as soon as
the appropriate numeric code is displayed.
Brief display of BUSY and the "o" symbol confirms your selection, fol-
lowed by a return to "zero" for the 2nd digit or "line."
How to return to the weighing mode:
Press the tare control each time a 0 appears in the numerical se-
quence (word, line, page). lf you have changed a menu code, it will be
stored as soon as the display returns to the weighing mode.
Lock the scale operating program using the menu access switch
("L" readout) and replace the protective cover.
To Next Page
Loading...
Need help?
General