Additional Functions
Print out parameter settings:
§ If “Device parameters” are displayed:
Press the r key
> Printout (example)
Lines with more than 20 characters
are truncated
--------------------
SETUP
DEVICE
--------------------
Interface
SBI
Baudrate
1200 baud
Number of data bi
7 data bits
Parity
Odd
Number of stop bi
1 stop bit
Handshake mode
Hardware handshake a
fter 1 char
Display contrast
2
Acoustic signal
On
--------------------
15
Reset the device parameters to the
factory settings:
§ Select the Setup menu:
Use the x or y key to select
SETUP in the Function line and press
u to confirm
> SETUP is displayed:
§ Select Device parameters:
Press the y key and press u
to confirm
$ If a password has been assigned: enter
the password as described above
§ Confirm the password and display
“Device parameters”:
Press the u key
> Device parameters are displayed
§ Select Factory settings:
Press the y key 4 times
§ Confirm Factory settings:
Press the u key
$ To cancel the “Reset” operation at
this point: Press the c key
§ Select Yes and confirm.
Press the y key and then
press the u key
§ Exit the Setup menu:
Press the c key three times
To Next Page
Loading...
