Mode
Parameters listed in the overview (see
previous page) under the
Mode item can
be temporarily changed. Each time the
moisture analyzer is turned on and off or
after parameters are changed in the Pro-
gram or Setup menu, the temporarily
changed parameters are deleted and over-
written by the parameters of the currently
loaded drying program.
Features:
Display parameters
Change parameters
Info (MA100 only)
During the drying program with phase dry-
ing as the heating program, intermediate
results of the drying phases can be dis-
played after the respective analysis time
has elapsed. The final result is displayed at
the end of the analysis.
Features:
Displays drying phases including time and
moisture loss
Displays final results at the end of analysis
If the display mode is set to weight loss
(mg), values are displayed in mg; other-
wise, as moisture (%L)
Displays information on an analysis run
after drying phase 2
Statistics (MA100 only)
Statistics are listed for each drying
program. The following values can
be displayed:
– Last analysis result
– Last analysis time
– Number of analyses
– Average (mean value)
– Standard deviation
– Lowest value (minimum)
– Highest value (maximum)
Features:
Statistics on the moisture analysis
results for up to 9999 analyses
Statistics stored as a part of the data
record for moisture analysis parameters
Update at the end of analysis routine
No update after 10,000 analyses,
analysis cancel, analysis with former
sample (100% function), at the end
of a asap analysis
Delete the last analysis result by
pressing the
M- soft key
Delete the statistics data with the
Delete soft key after you are prompted
for confirmation
Use-defined printout of statisics data by
using the p key
Display of statistics data
--------------------
STATISTICS
--------------------
Prg 1 1
--------------------
Res + 7.411 %L
Time 4.3 min
n2
Avg. + 8.705 %L
s 1.830 %L
Min + 7.411 %L
Max + 9.999 %L
--------------------
Display of statistics (also available with
GLP header and footer)
36
Example for Mode: Temporarily Changing the Unit for the Display Mode
You can temporarily change the unit for the display mode.
● Select
MODE: Press the Mode soft key
● Select
Display mode: Press the q soft key
● Confirm
Display mode: Press the O soft key
> Display mode appears
● Select the desired unit: Press the q soft key repeatedly
● Confirm the desired unit: Press the O soft key
> Decimal places are displayed
● Select the number of decimal places: Press the q soft key repeatedly
● Confirm the number of decimal places: Press the l soft key
● Exit
MODE: Press the oo soft key
To Next Page
Loading...
