Sartorius Microsart Series - Installing the Product; Unpacking

20 Operating Instructions Microsart
®
Manifold
Installation
4.3 Unpacking
Procedure
t Unpack the product.
t If the product is stored temporarily: Observe the
storage information (see Chapter “11.1 Storage”,
page 36).
t Install the product at the intended installation
location.
t Keep all parts of the original packaging, e.g. to
return the product.
4.4 Installing the Product
Procedure
t Install the following components (as needed) on
the ventilation hole (2):
− The sterile ventilation filter (without touching
the filter opening)
Or:
− The sealing plug
t Connect the product to the vacuum source via the
hose (1).
t Turn the valve stopcock to “Stop”.
t Ensure that the filtrate is being properly drained on
the pump side.
t Ensure that the sealing cap (3) is fitted.
1 32
Manual_Microsart_Manifold_W166001-e.indb 20 28.02.19 10:03