Sartorius Microsart Series - Returning the Product and Parts; Storage; Storage and Shipping

36 Operating Instructions Microsart
®
Manifold
Storage and Shipping
11 Storage and Shipping
11.1 Storage
Procedure
t If the product is in operation:
t Decommission the product.
t Properly clean and dry the product.
t Store the product according to the ambient conditions (see Chapter “13.5 Ambient
Conditions at the Installation Site”, page 40).
11.2 Returning the Product and Parts
Defective products or parts can be sent back to Sartorius. Returned products must be
clean, decontaminated, and packed in their original packaging.
Transport damage as well as measures for subsequent cleaning and disinfection of the
product or parts by Sartorius shall be charged to the sender.
WARNING
Risk of injury due to contaminated products.
Products contaminated with hazardous materials [nuclear, biological, or chemical
(NBC)] will not be accepted for repair or disposal.
t Observe the information on decontamination (see Chapter “12.1 Information on
Decontamination”, page 37).
Procedure
t Decommission the product.
t Contact Sartorius Service for instructions on how to return products or parts
(please refer to our website at www.sartorius.com for return instructions).
t Pack the product and its parts in their original packaging for return.
Manual_Microsart_Manifold_W166001-e.indb 36 28.02.19 10:03