Sartorius Microsart Series - Cleaning and Maintenance; Cleaning Product Surfaces; Maintenance Schedule

28 Operating Instructions Microsart
®
Manifold
Cleaning and Maintenance
7 Cleaning and Maintenance
7.1 Cleaning Product Surfaces
Requirements
The process is complete (see Chapter “6.3 Finishing the Process”, page 24).
Procedure
t Disconnect the product from the vacuum pump.
t NOTICE Corrosion or damage to the product due to unsuitable cleaning agents!
t Do not use corrosive, chloride-containing or aggressive cleaning agents.
t Do not use cleaning agents that contain abrasive ingredients, e.g. scouring
agents, steel wool.
t Do not use any solvent-based cleaning agents.
t Only use suitable cleaning agents (for materials, see Chapter “13.7 Approved
Cleaning Agents”, page 41) and observe the product information for the
cleaning agent used.
t Wipe the product housing with a damp cloth. Use a mild soapy solution or a
suitable cleaning agent for more severe contaminations.
7.2 Maintenance Schedule
Interval Component Action Chapter,
page
Daily Manifold Remove any product residues from
the manifold and rinse it with disin-
fectant and then sterile water.
7.3, 29
Empty the manifold with care. 7.3, 29
Weekly Valve
stopcock
Grease the valve stopcock. 7.5, 30
Vent filter Insert the new vent filter. 4.4, 20
Manual_Microsart_Manifold_W166001-e.indb 28 28.02.19 10:03