Sartorius Microsart Series - Getting Started; In the Process Structure; Integration of the Microsart

Operating Instructions Microsart
®
Manifold 21
Getting Started
5 Getting Started
5.1 Integration of the Microsart
®
Manifold in the Process
Structure
Requirements
t The product is connected with the vacuum pump (see Chapter “4.4 Installing the
Product”, page 20).
t The vacuum pump is switched off.
t The vacuum pump is connected to the power supply at the installation site.
Procedure
t Place the filtration unit or the filter and funnel (sterile) on the manifold.
Fig. 5: Process structure for the filtration (in this example, Microsart
®
1-way manifold with Biosart
®
100)
1
2
4
5
3
No. Designation
1 Vacuum pump (here: Microsart
®
e.jet)
2 Filtration unit (here: Biosart
®
100)
3 Drain hose
No. Designation
4 Vacuum hose with quick
coupling
5 Microsart
®
1-way manifold
Manual_Microsart_Manifold_W166001-e.indb 21 28.02.19 10:03