Operating Instructions Microsart
®
Manifold 31
Cleaning and Maintenance
Cleaning the Valve Stopcock
Procedure
t Clean the valve stopcock using a clean cloth.
t Ensure that the contact surfaces are clean and free
from particles.
t Grease the valve stopcock on the contact surface
using new high-vacuum grease.
Inserting the Valve Stopcock
Procedure
t Insert the valve stopcock into the manifold until
the rear stop. The handle’s thinner, shorter side
must point toward the left.
t Fit the valve stopcock with your left hand, and use
your right hand to install the knurled screw with
spring in such a way that the spring is vertical, or
that the spring is in the groove of the manifold.
Manual_Microsart_Manifold_W166001-e.indb 31 28.02.19 10:03
To Next Page
Loading...