Sartorius Practum - Page 81

Installation and Operating Instructions Secura, Quintix, Practum 81
Technical Specifications
Quintix
®
Model 612-1x
1
) 412-1x
1
) 6101-1x
1
) 5101-1x
1
) 2101-1x
1
) 6100-1x
1
) 5100-1x
1
)
Weighing capacity g 610 410 6,100 5,100 2,100 6,100 5,100
Readability mg 10 10 100 100 100 1,000 1,000
Repeatability
(standard deviation)
mg 10 10 100 100 100 500 500
Linearity mg 30 30 300 300 300 1000 1000
Sensitivity drift
between
+10 to +30°C
± ppm/K 4488888
Typical stabilization
time
s 1.5 1.5 1.5 1.5 1.5 1 1
isoCAL Settings:
– temperature change
– time interval
K
h
2
6
2
6
2
6
2
6
2
6
2
6
2
6
Display result
(depending
on the filter level)
s 0.1/0.2 0.1/0.2 0.1/0.2 0.1/0.2 0.1/0.2 0.1/0.2 0.1/0.2
Weighing pan size mm d 180 d 180 d 180 d 180 d 180 d 180 d 180
Net weight, approx. kg 4.7 4.7 4.7 4.7 4.7 4.7 4.7
Practum
®
Model 224-
1x
1
)
124-
1x
1
)
64-
1x
1
)
513-
1x
1
)
313-
1x
1
)
213-
1x
1
)
3102-
1x
1
)
2102-
1x
1
)
1102-
1x
1
)
612-
1x
1
)
412-
1x
1
)
6101-
1x
1
)
5101-
1x
1
)
2101-
1x
1
)
6100-
1x
1
)
5100-
1x
1
)
Weighing capacity g 220 120 60 510 310 210 3,100 2,100 1,100 610 410 6,100 5,100 2,100 6,100 5,100
Readability mg 0.1 0.1 0.1 11110101010101001001001,000 1,000
Repeatability
(standard deviation)
mg 0.10.10.11111010101010100100100500500
Linearity mg 0.2 0.2 0.2 22220303030303003003001,000 1,000
Sensitivity drift
between
+10 to +30°C
± ppm/K 2223334444488888
Typical stabilization
time
s 2221111.51.51.51.51.51.51.51.511
Weighing
pan size
mm d 90 d 90 d 90 d 120 d 120 d 120 d 180 d 180 d 180 d 180 d 180 d 180 d 180 d 180 d 180 d 180
Weighing chamber
height*
mm209209209209209209––––––––––
Net weight, approx. kg 4.5 4.5 4.5 4.9 4.9 4.9 3.1 3.1 3.1 3.1 3.1 3.1 3.1 3.1 3.1 3.1
Model-specific Data
FCC Rules
Safety Precautions:
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
Modifications: Any modifications made to
this devices that are not approved by Sartorius
Lab Instruments GmbH & Co. KG may void the
authority granted to the user by the FCC to
operate this equipment.
1
) Possible terms for country-specific models:
x = S: Standard balances without country specific
additions
x = SAR: Standard balances with country specific
additions for Argentina only
x = SJP: Standard balances with country specific
additions for Japan only
x = SKR: Standard balances with country specific
additions for South Korea only
* Upper edge of the weighing pan to the lower
edge of the upper draft shield panel
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver
– Consult the dealer or an experienced radio/TV
technician for help.
Shielded Cables: Connections between the
devices and peripherals must be made using
shielded cables in order to maintain compliance
with FCC radio frequency emission limits.