Setup
utilit
7
Operation
(Display designation of this menu level: 7)
8.3. Keys
8.3.1* All available
8.3.2 All blocked
8.3.3 Numeric keypad Signum 3 only
8.3.4 Toggle weighing platform Signum 2 and 3 only
8.3.5 Zero
8.3.6 Tare
8.3.7 FN
8.3.8 isoTEST
8.3.9 Print
8.3.10 x10 Signum 2 and 3 only
8.3.11 Toggle gross/net Signum 2 and 3 only
8.3.12 CF Signum 3 and 3 only
8.3.13 Ref Signum 3 and 3 only
8.3.14 OK Signum 3 and 3 only
8.3.15 Toggle Signum 2 and 3 only
8.3.16 Info Signum 2 and 3 only
8.3.17 D Signum 3 only
8.3.18 ID Signum 3 only
8.3.19 Mem Signum 3 only
8.7. Automatic shutoff of display and control unit
8.7.1 Automatic shutoff acc. to menu item 8.9.
8.7.2* No automatic shutoff
8.8. Display lighting
8.8.1* On
8.8.2 Off
8.8.3 Automatic shutoff acc. to menu item 8.9.
8.9. Timer mode
8.9.1* After 1 + 1 minute not in use
(after 1 min.: warning
2)
displayed for 1 minute)
8.9.2 After 2 + 2 minutes not in use
(after 2 min.: warning
2)
displayed for 2 minutes)
8.9.3 After 5 + 5 minutes not in use
(after 5 min.: warning
2)
displayed for 5 minutes)
8.11. Main scale: first platform displayed on start-up
8.11.1* Weighing platform WP1
8.11.2 Weighing platform WP2
8.12. Show geographical data before calibration
8.12.1* No
8.12.2 Yes
9.1. Restore factory settings in numeric operating menu
9.1.1 Yes
9.1.2* No
1)
More than one can be selected
2)
Warning: the W symbol and weighing platform numbers 1 and 2 flash simultaneously
* Factory setting
Configuration
36
To Next Page
Loading...
