Product at photo sensor (conveyor belt outlet):
Product at outlet detected (photo sensor)
Output of measured value to serial interface (RS-232, ASCII, 16 characters):
40 – 70 ms
Setting the control outputs <, =, >
100 ms (< or = or > or no signal)
Conveyor belt speed Setting in control cabinet
The conveyor belt speed is set in the control cabinet, at the motor controls, by changing
the motor frequency in the frequency converter.
Please refer to the enclosed operating instructions for the frequency converter for infor-
mation on the available settings.
Standard value: approx. 75 Hz 36m/min, linear dependency, 30 Hz/min. 15m/min.
Instructions for Recycling the Packaging
To ensure safe shipment, our products are packaged using environmentally friendly
materials. After successful installation of the equipment, you should return this packaging
for recycling. For information on recycling options, including recycling of old weighing
equipment, contact your municipal waste disposal center or local recycling depot.
§ Deinstallation of the electrical connections and peripheral equipment must be performed
by trained technicians.
§ Avoid environmental pollution; e.g., due to uncontrolled emission of oil (gear oil) or
other lubricants from the system. Dispose of used oil in accordance with environmental
protection regulations.
20
To Next Page
Loading...
