2. When the (FA)st cooling cycle rate is selected in the configuration menu,
(see configuration menu item 2), the thermostat will call for cooling at 0.5ºF (0.5ºC)
above set-point, and turn off set point. When the (SL)ow cool cycle rate is selected,
the thermostat will call for cooling at 1.5ºF (1.5ºC) above set-point, and turn off at
set-point. When the thermostat calls for cooling, the display will show COOL On.
If the COOL On display is flashing, the compressor lockout feature is operating.
mode. (Note: See Configuration menu item 8).
If all functions operate properly, the thermostat is installed correctly.
To Next Page
Loading...
