43
(Shown
below, near
on
display
(in brackets is the factory
default value)
If you have this function enabled (On), the thermostat will
start to heat before the next heating program schedule will
start and with that it will achieve a more comfort way of
heating. The thermostat learns regarding the last 5 days
of heating conditions and how much time it took to get to
the desired set temperature. For example – if it needed 30
minutes to get from 20°C to 22°C it will start heating 30
minutes before the next heating program with 22°C
Antifreeze protection. The thermostat will turn on heating,
if the temperature falls below 5°C.
100 = Sensor with 100K resistance
10 = Sensor with 10K resistance
All of the advanced settings can be reset to factory default values by holding the middle menu button (button
description 3) for 3 seconds, while in editing mode. Screen will display dEF and all settings will be reset.
To Next Page
Loading...
Need help?
General
