中文
EN DE RU KO PT JA ES
03015/03017
35
Measuring DC voltage:
1） Connect the black probe to " " jack and the red probe to " " jack.
2） Set the function switch to the " " position.
3） Connect the probes to the two ends of the power or circuit to be measured.
4） Take readings on the screen, and the polarity of the end connected to red test probe will also be indicated.
Measuring AC voltage:
1） Connect the black probe to " " jack and the red probe to " " jack.
2） Set the function switch to the " " position.
3） Connect the probes to the two ends of the power or circuit to be measured.
4） Take readings on the screen,
Note:
To avoid electric shock or damage to the meter, do not apply a voltage greater than 1,000V to the input.
Note:
To avoid electric shock or damage to the meter, do not apply a voltage greater than 100V to the input.
Measuring DC or AC current:
1） Connect the black probe to " " jack.
03015: If the absolute value of current to be measured is lower than 400mA, connect the red test probe to " " jack. If the
absolute value of current to be measured is equal to or greater than 400mA （≤ 20A）, connect the red probe to " " jack.
03017: If the absolute value of current to be measured is lower than 600mA, connect the red test probe to " " jack. If the
absolute value of current to be measured is equal to or greater than 600mA （≤ 20A）, connect the red probe to " " jack.
2） Set the function switch to the desired position " ", " " or " ".
To Next Page
Loading...