Satel TD-1 - Sound Signaling; Alarm; Programming; User Menu

4 TD-1 SATEL
The following messages may be also displayed:
internal sensor fault.
the external sensor is faulty or disconnected. This message can be
displayed in the event of incorrect configuration of the S1-S3 input
(see description of the function F9 p. 6).
the external probe is not supported by the detector (see description
of the function F9 p. 6).
5.1 Sound signaling
1 short beep – pressing the or button,
3 short beeps:
 obtaining an access to installer menu;
 pressing the button;
 automatic exit from the menu.
intermittent tone – alarm.
5.2 Alarm
In case of an alarm, the display will show alternately: the current temperature and the name
of function in which the critical parameters have been defined. To turn the audible alarm off,
press the button. The function name will be displayed until the temperature conditions
return to the acceptable range.
6. Programming
Notes:
 If no button is pressed for 45 seconds, the menu will be automatically exited (changes that
have not been accepted will not be saved).
 If the S1-S3 input supports a bistable switch (see F9 function description), the critical
parameters programmed for the external sensor will become a second set of critical
parameters for the internal sensor.
6.1 User menu
The user functions allow programming the low and high temperature thresholds. The
temperature thresholds are distinguished as follows:
high temperature threshold for the internal sensor;
low temperature threshold for the internal sensor;