Satlink WS6922 - Trouble Shooting

20 / 20
6 Trouble Shooting
Problem
Possible Causes
What To Do
No display light up
Power switch is not on
Run out of batteries
Black led is off
Check to make sure power on.
Even on adapter.
Press B.light key
No sound or picture, but the
front panel power light is ON.
AV IN jack insert, but no
video input
Pull out AV IN cable
No sound or picture
The satellite dish is not
pointing at the satellite.
Adjust the dish. Check the
Signal Level in the Antenna Setup
Menu
Bad picture/Blocking Error
No signal or weak signal
Check the cable connections. LNB and
other equipment connected between
the LNB and the meter and adjust the
dish.
The satellite dish in not
pointing at the satellite
Adjust the dish.
Signal is too strong
Connect a signal attenuator to the
LNB input
Satellite dish is too small
Change to a larger dish
LNB noise factor too high.
Change to an LNB with lower noise
factor
The LNB is faulty.
Change the LNB
AV out No picture(Video)
The system is connected by
SCART cable and TV is not in
AV mode.
Check the UHF channel fixed in your
system and tune the UHF properly.
The key is not working.
Out of battery
Even on adapter
Key blocks
make sure no blocks between the
front panel
Note: If you still cannot resolve the problem with above reference. Please contact the local dealer or their
after-sales service center.