8 / 20
3.1.5 Frequency
Frequency of the current transport, Input the value by using the numeric keys.
3.1.6 Symbrate
Symbol rate of the current transport, Input the value by using the numeric keys.
3.1.7 Pol
Press ◄► key to change Vertical or horizontal of polarization.
3.1.8 NIT Search
Press ◄► key to on or off NIT Search.
3.1.9 LNB Power
Press ◄► key to select the desired option. If your meter is connected to another receiver through LOOP
THROUGH support, in case the other receiver is directly connected to the LNB, then select OFF.
3.1.10 LNB 22KHZ
22 KHz control is automatically set for each LNB alternative. If “Universal” is selected, 22 KHz control should be
“off state”.
3.1.11 DisEqc type & Input
Press ◄► key to set the port type or number, which get the RF signal from the LNB, if the LNB is connected to
DiSEqC switching box.
3.1.12 Motor
If you use the equipment of motor, According to
your motor category, the meter provides
DiSEqC1.2/USALS, let you have exact information
to direct your antenna toward a satellite.
Press ◄► key to select Motor type, then press
OK key into interface of motor sett
USALS SET
￭ Satellite: Press ◄► key to select the desired
satellite.
￭ Frequency: Press ◄► key to select the TP.
To Next Page
Loading...
Need help?
General
