To Next Page
P
peter61Aug 27, 2025
What to do if my SATO CG412DT labels are not dispensed?
- AAshley ArmstrongAug 27, 2025
If labels are not dispensed from your SATO Printer: Set dispenser unit correctly Clean the Dispensing roller and Platen roller.
What to do if my SATO CG412DT labels are not dispensed?
If labels are not dispensed from your SATO Printer: Set dispenser unit correctly Clean the Dispensing roller and Platen roller.
What to do if my SATO CG412DT shows 'Ribbon near end'?
If your SATO Printer displays 'Ribbon near end', it indicates that there is not much ribbon left. Replace the ribbon to resolve this issue.
What to do if my SATO CG412DT Printer is not feeding media?
To address the issue of your SATO Printer not feeding media: Set media correctly, Set the sensor correctly by Utility Tool setting Check the connection of sensor cable. Adjust sensor level Clean the platen roller.
What to do if my SATO CG412DT displays 'Ribbon end' error?
If your SATO Printer shows a 'Ribbon end' error, it means that the printer is either out of ribbon or the ribbon is ripped, or the ribbon is not set properly. To fix this, set the ribbon properly.
Provides technical specifications for the CG4 Series printer, including physical, power, and print details.
Describes the basic specifications, connector, and communication settings for the RS232C interface.
Lists how to set various printer configurations via commands or utilities.
Helps interpret error signals from LED indicators and buzzers for hardware/program errors.
Provides step-by-step flowcharts for diagnosing and resolving common printer problems.
Provides step-by-step instructions for replacing the print head and platen roller.
Details the procedure for replacing the main circuit board (PCB) of the printer.
General
