SATO CL612e Adjustment

CL608e/612e
Mechanical Adjustments
SATO CL608/CL612 printers contain adjustable sub-assemblies. This means that during
your regular maintenance, your service technicians are able to make adjustments to
reset the printer to factory specifications thereby ensuring optimum performance of
your printer.
The main mechanical sub-assemblies are:
• Ribbon Unwind/Rewind Assembly's
• Ribbon Guide Roller Assembly
• Print Head Assembly
• Drive Belt Assembly's
In this section you will find procedures for:
• Ribbon Unwind/Rewind Clutch Adjustment
• Print Head Position Adjustment
• Print Head Balance Adjustment
• Ribbon Roller Adjustment
• Ribbon Tension Balance Adjustment
• Feed Roller Adjustment
• Timing Belt Tension Adjustment
• Head Latch Adjustment
• Notch/Gap Sensor Adjustment
SATO America, Inc
545 Weddell Drive
Sunnyvale, CA 94089
Main Phone: (408) 745-1300
Tech Support Hotline: (408) 745-1379
Fax: (408) 745-1309
®
Proc 64

SATO CL612e Specifications

General

Print Technology	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Processor	32-bit RISC
Media Type	Labels, Tags, Receipts
Ribbon Width	110 mm
Ribbon Length	300 m
Memory	8 MB SDRAM
Interfaces	Ethernet
Supported Barcode Types	PDF417, Data Matrix, QR Code, MaxiCode, Aztec
Power Requirements	AC100-240V ±10%, 50/60 Hz
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 60°C
Operating Humidity	20% to 85% RH
Storage Humidity	10% to 90% RH