▼
▼
▼
▼
four different tasks in sequence while storing each task’s data in one of the four
different memory blocks (pages). This is ideal when you want to collect data
from multiple sites using one Datalogger.
Tips: The memory is used on a page-by-page basis. Therefore, even if there
are less than 2000 stored data lines at the end of logging (REC/STP
pressed), the entire page containing any number of lines becomes
unavailable for further use.
Upon logging again, the new data will be stored in a different unused
page. When the four pages are used up, erase all the data before
performing the next logging.
Dividing into four blocks, each to store up to 2000 lines of data.
Start logging End logging End logging End logging End logging
Start logging Start logging Start logging
Memory indicator (two bars represent 2000 lines of data per page)
Example 1: The rst page has 500 and the second page has 1500 lines.
Example 2: The rst and fourth pages have 500 lines each, the second has
1500 lines and the third has 1200 lines.
To Next Page
Loading...