SATO SK-L200 II Series - Page 63

−61 −
Tip: Aside from the steps below, you can also set this function from
DATALOGGER for Windows. For further information, please refer to the
online Help.
For example, if you want to start logging at 10:30 am, Sep. 1, 2012.
(1) Press and hold the POWER ON/OFF key for one second or more to turn
on the Datalogger.
The LCD turns on to indicate that the SK-L200T II or SK-L200TH II
α
is in
the measurement state for temperature or temperature and humidity,
respectively.
(2) Press the MODE key 11 times (L200T II) or 13 times (L200TH II
α
).
Note: The key must be pressed correctly depending on the model being used.
Press the MODE key until the RES mark is displayed on the LCD.
(3) The RES mark of the LCD lights. Use the
▲
or
▼
key to display "On"
(4) Press the REC/STOP key to conrm.
The "year" digits start ashing. Use the
▲
or
▼
key to set to "2012"
(5) Press the REC/STOP key to conrm the year setting.
(6) The "month" digits start ashing. Use the
▲
or
▼
key to set to "9"