SATO SK-L200 II Series - Page 64

−62 −
(7) Press the REC/STOP key to conrm the month setting.
(8) The "date" digits start ashing. Use the
▲
or
▼
key to set to "1"
(9) Press the REC/STOP key to conrm the date setting.
(10) The "hour" digits start ashing. Use the
▲
or
▼
key to set to "10"
(11) Press the REC/STOP key to conrm the hour setting.
Note: The Datalogger uses the 24-hour clock format.
(12) The "minute" digits start ashing. Use the
▲
or
▼
key to set to "30"
(13) Press the REC/STOP key to conrm the minute setting. The LCD goes
out and the RES mark lights to indicate that the Datalogger enters the
standby state for preset start.
Note:
・
The preset start date and time must be later than the current date
and time.
・
For setting, make sure to connect a probe with the main unit. (When
Er is indicated on the LCD, the date and time can not be set.)
Tips: To conrm the settings while in the standby for preset start, press the
MODE key. Pressing the key once displays each setting at a time. To
change any of the settings, refer to the instructions for each setting.