●
Displays the approximate amount of memory currently used.
(
→
P.52)
Easy to determine how much more logging is possible.
●
Probes can be interchangeablely used.
The probes are fully compatible among the series models so that, in case
of probe failure, it is easy to replace by interchanging with another probe.
●
14 logging intervals (
→
P.50)
The logging intervals available are in seconds (1, 2, 5, 10, 15, 30) and in
minutes (1, 2, 5, 10, 15, 30, 60, 90).
●
ID on each Datalogger (
→
P.48)
The ID numbers of 1 to 9 can be set for easy identication when multiple
Dataloggers are used.
●
No data loss even if the batteries go dead
There is no data loss even if there is a power failure, as the logged data is
stored in the EEPROM.
●
Warning display for upper/lower limit of temperature or
humidity
The Alarm mark lights on the LCD if the temperature or humidity exceeds
the preset threshold. This helps to prevent damage to your product.
To Next Page
Loading...