English
21
Turning On Power
This section explains the power cord and interface cable connection procedures.
Instruction to attach the ferrite cores to the power cord
Attach the ferrite cores to the power cord as shown below.
• Attach the ferrite cores to the both end of the power cord as shown in the drawing.
Power outlet end Printer end
* Make sure to squeeze the ferrite core until it clicks.
* Shape of the power cord end is varied depend on the specification.
Connecting the Power Cord
1 Connect the power cord to the AC inlet power
terminal on the rear panel of the printer.
Make sure that the cord is correctly oriented.
Secure the printer with one hand, and insert the cord firmly.
• Be sure to connect the ground wire. Failure to do so may cause an electric shock.
• Do not operate the power switch or insert/remove the power cord while your hands are wet. Doing so may
cause an electric shock.
The power cord provided with this printer is for use with this printer only. It cannot be used with other electrical
devices.
WARNING
CAUTION
To Next Page
Loading...
