2 Update Firmware Update Firmware in Atmel Mode
19
6. Click Send to send the firmware files to your printer. When the update is
complete, the message “Done” appears. Click Close to close the dialog box, or
click Save Log to save the firmware update log.
Step 3. Exit Atmel Mode
This part describes how to exit Atmel mode.
1. Turn off your printer.
2. Set DIP Switch 1 and 2 to the ON position (up). If it’s inconvenient to set DIP
Switch while cables are connected, unplug all the cables to do this.
3. Reinstall the base and the secure it with 3 screws.
4. Turn over your printer.
5. Turn on your printer.
To Next Page
Loading...
