1 Accessories Installation Cutter
2
1 Accessories Installation
This chapter describes how to install accessories on your printer.
1.1 Cutter
A cutter is used to cut the label after it is printed out. Full cutter cuts a label off
from a media roll.
To install a cutter:
Step 1. Remove the base frame
This part describes how to dismantle your printer.
1. Open the top cover and Remove tear bar.
2. Turn over your printer.
3. Loosen and remove 3 screws from the base.
4. Remove the base frame.
Step 2. Connect the cutter to the main board and Secure the cutter
to your printer
To Next Page
Loading...
