1 Accessories Installation Peeler
5
1.2 Peeler
A peeler automatically removes the liner from the printed label. The peeler sensor
detects if a peeled label is taken away.
To install a peeler:
Step 1. Remove the base frame
This part describes how to dismantle your printer.
1. Open the top cover and Remove tear bar.
2. Turn over your printer.
3. Loosen and remove 3 screws from the base.
4. Remove the base frame.
Step 2. Connect peeler to the main board then secure it
This part describes how to thread the peeler cable and plug to the mainboard.
1. Thread the peeler cable through two square holes as below.
To Next Page
Loading...
