1 Accessories Installation Cutter
4
7. Secure the cutter with 2 screws.
Step 3. Test the cutter
This part describes how to use the cutter to cut your label.
1. Place the media roll between the holders. Make sure the print side is up and
the media roll is clamped tightly by the holders.
2. Pull the media until it reaches out of your printer. Thread the media under the
media guides.
3. Thread the media into the slot of the cutter.
4. Close the top cover.
5. Send a print job or press the FEED button to test if the cutter works.
To Next Page
Loading...
